Knowledgebase
Faculty of Business and IT > FBIT Lab Support System > Knowledgebase

Search help:


» Category: Networking Lab  (Go back)

» Articles in this category:

 
How do I change my password?
How to change the password associated with your profile At the beginning of the semester you were asked to configure your user profile for the Networking Lab, which included changing your password an...
Log Into Pods (Local)
How to Log Into the Pods from Within the Classroom Use the following instructions to connect to one of the networking pods while inside the lab: Plug an ordinary straight-through Ethernet cable ...
Router Password Recovery
Cisco Router Password Recovery Procedure All passwords used in the lab should be either cisco or class. In the event that neither of these passwords work, you can perform a password recovery by follo...
Switch Password Recovery
Cisco Switch Password Recovery Procedure All passwords used in the lab should be either cisco or class. In the event that neither of these passwords work, you can perform a password recovery by follo...
Connecting to the Networking Lab Access Wireless Network
Connecting to the Networking Lab Access Wireless Network The Networking Lab Access wireless network can be used to connect to the console ports of the pod equipment instead of using the access ports ...
Installing the Networking Lab CA Certificate in Internet Explorer
Installing the Networking Lab CA Certificate in Internet Explorer Many of the websites used in the networking lab are protected by SSL using a centralized Certificate Authority (CA) provisioned in th...
How do I change my e-mail address?
How to change the e-mail address associated with your profile At the beginning of the semester you were asked to configure your user profile for the Networking Lab, which included changing your passw...
How do I erase my router configurations when I'm done with the router?
How to erase router configurations This article assumes that you are already connected to the router and have access to the EXEC mode CLI (i.e. the prompt ends with a # sign, similar to Router#. If y...
How do I erase my switch configurations when I'm done with the switch?
How to erase switch configurations This article assumes that you are already connected to the switch and have access to the EXEC mode CLI (i.e. the prompt ends with a # sign, similar to Switch#. If y...
 

 
Powered by Help Desk Software HESK, brought to you by SysAid