Playstation VR (for PS4)

PlayStation VR (for PS4)

Model: PSVR CUH-ZVR1

Hardware:

• If the PlayStation VR headset is not already connected, follow the instructions below.

1. Plug PS4 to a power outlet.

2. Set down the Processor Unit (Image of the device below).

3. Plug the one end of an HDMI cable to the PSVR Processor Unit, and the other end to the TV (labeled as HDMI TV on Processor Unit).

4. Plug PlayStation Camera to the back of the PS4.

5. Plug in another HDMI cord with the one end to the Processor Unit and the other to the PS4 (labeled as HDMI PS4 on Processor Unit).

6. Plug in the USB to Micro-USB cord with one end going to the PS4, and the other to the back of the Processor Unit.

7. Plug the AC adaptor to the back of the Processor Unit, and then connect AC power cord with the adaptor and plug it into a power outlet.

8. Slide back the Processor Unit cover and plug in the VR Headset cable.

9. Connect the Headset with the cable.

Optional:

• If you want audio, you can connect your headphones to the headphone on the inline remote (Remote shown in image below).

Getting Started:

• You can turn the headset on by pressing the power button on the inline remote.
• Press the release button on the back of the headband and pull the front section forward in order to wear the headset.
• You can adjust the headset to make it tighter by adjusting the dial found on the back of the headband (Tighten it just enough to stop movement, but not far enough that it’s too tight).
• In order to remove the headset, once again press the release button on the back of the headband and pull the headset forward and away from your face to re-extend the headband.